Macsense Connectivity MIH-120 Manual do Utilizador descarregar pdf (Página 17)

5.2 Mac OS TCP/IP Configuration

1. Open the TCP/IP control panel.

2. In the Connect via menu select the Ethernet interface installed on your

computer.

3. In the Configure pull-down menu, select Using DHCP Server to allow the

built-in DHCP server of the XRouter Aero to assign an IP address and other

TCP/IP configuration information to the client automatically. Do this for every

client which needs Internet access through the XRouter Aero. (See Figure

12)

Figure 12

Note: The DHCP Client ID in the Macintosh TCP/IP Control Panel field is not

required when connecting the XRouter Aero. It is normally used to identify

computers in a DHCP network.

4. Close the TCP/IP window and save the changes.

5.2.1 Assigning TCP/IP Values Manually

If you already have a DHCP server on the network, or if you prefer not to use the

XRouter Aero’s DHCP server to assign TCP/IP values automatically, you can

input these values manually.

To manage the computer’s address manually, perform the following steps:

1. In the Connect via menu select the Ethernet interface installed in your

computer. (See Figure 13)

2. In the Configure menu select Manually.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Sem comentários

Macsense Connectivity MIH-120 Manual do Utilizador Página 17